E&H India "Virtual Factory Tour" is ready.
Now new 5-minutes Virtual factory videos for our INDIAN plant "E&H India" is available. Please click the below to dive into our factory...
top of page
Thailand
India
Japan
NEWS
Search
May 24, 20221 min read
Machining diagonal corners on hexagonal material
Clamping the hexagonal material with diagonal corners would not make positional accuracy of boring inner diameter since material surface...
May 17, 20221 min read
Changing Solid Rods to Pipe material
Producing the machined products that have a hollow through-hole from Solid Rods material, it is necessary to drill the through-hole from...
May 17, 20221 min read
Changing Carbon steels to free-cutting steels
Carbon Steel S10C in JIS, AISI 1010 or C10 in ISO has difficulty in breaking up cutting chips during machining process, and it worsens...
May 17, 20221 min read
Changing to Annealed raw material
Annealing or magnetic annealing shall be done after machining process to stabilize the magnetic properties for some magnetic stainless...
May 17, 20221 min read
Adding Copper on Stainless steel material
Stainless steel SUS303 in JIS, or X10CrNiS18-9 in ISO 15510 or EN 1.4305 or AISI 303 are often used for shafts as free-cutting stainless...
May 12, 20221 min read
Grinding after machining process, instead of using ground material
Some products such as shafts and pistons that require precision tolerances in surface roughness and cylindricity. In some cases ground...
May 12, 20221 min read
Material cost reduction through applying plating
Stainless steel is generally used for parts that require corrosion resistance, but stainless steel is expensive. In the case of products...
bottom of page